Industrial maintenance / In development / Tester access opening this week

The right replacement.In your hands.

Tekvisio brings Vision-assisted identification, technical verification and manufacturer-neutral replacement evaluation into one workflow. Start with component and nameplate photos, then check the relevant technical requirements.

TEKVISIO / WORKFLOW01—03
MECHANICAL FIT / TECHNICAL COMPATIBILITY
1
ScanIdentify
2
VerifyCheck fit
3
ReplaceAct with confidence
Maintenance without limits

Built around the reality of the factory floor.

No supplier catalogue as the end goal. Tekvisio is designed around the technician who needs a practical replacement decision.

⌕

Vision-assisted identification

Use Vision to scan component and nameplate photos and bring visual information into the identification workflow. Technical compatibility is checked separately.

✓

Verification-led data

The planned database is being developed around checked, mapped and audited technical data.

⌕

For the technician

Focused on practical maintenance: identify what is installed, verify what fits and get the machine moving again.

◇

Manufacturer-neutral

The intended replacement logic is based on verified technical compatibility rather than preference for a particular manufacturer.

Initial scope

One workflow across critical maintenance components.

01

Motors

Identify motor data and compare verified mechanical replacement requirements across supported manufacturers.

02

Gearboxes

Bring motor and gearbox interfaces together so technicians can verify practical mechanical fitment.

03

Bearing units

Extend the same maintenance-first approach to bearing-unit identification and replacement.

Preview

Scan. Verify. Replace.

Tekvisio is in development, with tester access opening this week. Vision supports photo-assisted identification. The recorded API example below shows technical verification, not a live photo scan.

A real, API-verified example

Keep the motor. Verify the replacement.

Watch one existing drive move from identification to a checked gearbox candidate. No input needed.

Loading the recorded technical example…

Recorded technical case /

Technical analysis

Two ways to read the same API-verified result.

Technical selectionMATCH
Installation / final replacementVERIFICATION REQUIRED

Technical comparison

Nominal motor and machine interfaces for this selected configuration. No load or service-factor calculation was requested.

Selection checks from the existing replacement API
PropertyExisting / requiredCandidateAPI

Still to verify on the installation

Full API check register and evidence

PASS, FAIL, UNKNOWN and non-applicable states are retained. Informative installation notes are identified separately from required checks.

Manufacturer documentation and source references
Reproducibility and dataset reference
Original API test request
API discovery request

This recorded example is not a public catalogue release or installation approval. Another motor, option, ratio or installation requires its own assessment.

Contact Tekvisio

Questions, testing or product enquiries?

Send us a message and it will be delivered to info@tekvisio.net.

Tekvisio is in development, with tester access opening this week. Contact us about testing, maintenance workflows or product availability.

Coming soon

Industrial maintenance, made easier to verify.

For product information, testing enquiries or other questions about Tekvisio, contact us by email.

Contact Tekvisio